how to draw a grizzly bear

Practice you think drawing a bear is difficult? In this tutorial, you'll acquire how to draw a Grizzly bear in an easy step-by-stride way.

You'll exist a primary at cartoon bears afterward following these 12 simple steps.

Let's get started!

Drawing Supplies Needed

You can utilize any drawing supplies to draw a comport, but hither are the best tools for drawing.

Step ane

Start with a circle.

Footstep 2

At the bottom of the circle brand a U shape extending a little bit into the circle.

Footstep 3

From the top of the circumvolve make a mountain-shaped line with two peaks, the furthest peak from the circumvolve should extend down to the bottom of the page.

Pace 4

Now create leg guidelines! Below the U shape at the front end make a modest J-shaped line.

Now, a chip to the left of that leaving a large gap makes a curved lowercase "L" line.

Finally at the back only a very short bent line.

These are the guidelines for our bear'south legs.

Step 5

Now on the circle, we're going to employ a technique we haven't yet: Face up guidelines.

These lines across in a curve and down in a curve help us mark out the optics and brow shape!

At the same time create a curved line to shut the gap between the two inner leg guidelines.

Pace 6

On the left of our forehead line, nosotros'll brand a soft triangle shape, and mimic that on the outside of the peak of the circle for our ears.

Step vii

Time to make these legs take shape! Under the head to the left of the snout, we'll make a line that is wider at the top and curved inwards equally it extends down.

From that line, correct under the widest part, create a curved line going towards the height of the "J" shaped line under the snout.

At the back of the belly line we fabricated in the previous step, extend it downwards going further in as y'all go for the hind leg.

Finally, a short line across the remaining leg guideline will round out the four legs.

Step 8

Fourth dimension for feet!

Connect the leg lines together with a rounded line thinking of how Grizzly bears have toes and claws!

Step 9

Now, erase some of the caput circle and overlapping lines with the snout.

Footstep ten

Permit'southward start fleshing out the confront! at the right corner of the snout make a blackness circumvolve with a little missing as if someone took a seize with teeth out of it.

Then, nether that leaving some space first, make a small line going inwards towards the head.

Along the curved horizontal line make a black dot for the eye.

At present, marking out the within of the ears!

Step 11

Add the second eye where the horizontal line meets the snout then erase the face guides.

On the back of three of the legs add small lines for fur!

Step 12

Now here is where the behave takes shape! Fill the acquit with a medium shade color, I used a medium grey here.

Then, make out the shadows with a slightly darker lighter pressure castor.

I put these darker patches nether the mentum where the shadow would autumn on the front leg, behind the head, in the dip in the back, the back leg, where the legs meet the body, and effectually the optics.

NOW hither's the trick to making fur.

Take either a smaller-sized brush if you're working digitally, or if you're working with paper and pencil sharpen your pencil to a fine betoken.

Making fur is time-consuming so you'll need to have patience!

Start making minor lines in the direction of the trunk movement so do another layer with more pressure.

Yous desire to make sure you take dark lines and light lines and have them vary.

Then, finish off with a color lighter than all the other lines for the highlighted strands!

This will accept a lot of time so don't rush, and have fun with it.

Use whatever colors you desire, y'all can use browns if you desire to go straight into colour or stay with black and white if you adopt.

Once you have the fur looking like you wish, erase the thicker fur lines we made in the previous step if yous're working digitally, or only thin them out with a highlighted colour if not-digital.

Make the lesser of the feet a solid night color and add a highlight to the nearest eye to the viewer, and lighten the terminate of the snout.

Most of the work for animals really comes from the shading and then utilize this time to experiment!

Materials

Pencil
Newspaper
Or tablet and stylus

Tools

Pencil
Paper
Or tablet and stylus

Instructions

Step 1
Commencement with a circle.
Stride two
At the bottom of the circumvolve make a U shape extending a little scrap into the circumvolve.
Step three
From the meridian of the circle make a mount-shaped line with two peaks, the furthest tiptop from the circumvolve should extend downwards to the lesser of the page.
Pace four
At present create leg guidelines! Below the U shape at the front make a small-scale J-shaped line. Now, a bit to the left of that leaving a large gap makes a curved lowercase "L" line. Finally at the dorsum just a very brusk aptitude line. These are the guidelines for our bear'southward legs.
Step five
Now on the circle, we're going to use a technique nosotros haven't still: Face up guidelines. These lines across in a curve and down in a bend assist u.s.a. mark out the eyes and brow shape!
At the aforementioned time create a curved line to close the gap between the 2 inner leg guidelines.
Footstep half dozen
On the left of our forehead line, we'll brand a soft triangle shape, and mimic that on the exterior of the elevation of the circle for our ears.
Stride 7
Time to make these legs take shape! Under the head to the left of the snout, we'll make a line that is wider at the top and curved inwards as it extends down. From that line, right under the widest role, create a curved line going towards the tiptop of the "J" shaped line under the snout.
At the back of the belly line nosotros made in the previous step, extend information technology downwards going further inward every bit you go for the hind leg. Finally, a short line across the remaining leg guideline will circular out the 4 legs.
Footstep eight
Time for feet! Connect the leg lines together with a rounded line thinking of how Grizzly bears have toes and claws!
Step 9
Now, erase some of the caput circumvolve and overlapping lines with the snout.
Stride 10
Let's start fleshing out the face! at the correct corner of the snout make a black circle with a little missing equally if someone took a bite out of it. So, nether that leaving some space commencement, make a small line going inwards towards the head.
Forth the curved horizontal line brand a black dot for the centre.

Now, marker out the inside of the ears!
Step11
Add the second eye where the horizontal line meets the snout and and then erase the face up guides. On the back of iii of the legs add small lines for fur!
Footstep 12
Now here is where the comport takes shape! Make full the bear with a medium shade color, I used a medium grey here. And then, make out the shadows with a slightly darker lighter pressure castor.
I put these darker patches under the mentum where the shadow would fall on the front leg, behind the caput, in the dip in the back, the back leg, where the legs meet the body, and around the eyes.

At present here's the trick to making fur. Take either a smaller-sized castor if you're working digitally, or if you're working with paper and pencil sharpen your pencil to a fine bespeak. Making fur is time-consuming so yous'll demand to take patience!

Start making small lines in the direction of the body move then practise another layer with more than pressure. You want to make sure you accept dark lines and light lines and take them vary. Then, cease off with a color lighter than all the other lines for the highlighted strands!

This will have a lot of time so don't rush, and take fun with it. Use whatever colors you want, y'all tin employ browns if you lot want to go straight into colour or stay with blackness and white if you adopt.

Once you have the fur looking like you wish, erase the thicker fur lines nosotros made in the previous step if yous're working digitally, or simply thin them out with a highlighted colour if non-digital.

Make the lesser of the feet a solid night colour and add together a highlight to the nearest eye to the viewer, and lighten the cease of the snout.

Most of the piece of work for animals really comes from the shading so use this time to experiment!